A1 MINI Toolbox // Print-in-place

// APPLICABLE ADDITIONS //

A1 MINI TOOLBOX

/ Print-in-place

The perfect mini toolbox for the Bambulab A1 Mini is here! 🧰✨ Designed to match the compact power of the A1 Mini, this classic print-in-place toolbox keeps your setup neat, organized, and ready to roll. Small but mighty — just like your printer! 😎

Hop on and see why it’s quickly becoming a must-have for every A1 Mini owner! 💬🙌

Update:

1.) Based on the many feedback I might made a mistake in the cover photo. Purely based on the pic you can assume that the hotend tray goes to the top half of the case, but I only did it that way becasue it looked satisfying on the photo. It is designed to be placed upon the bottom half of the box ( paralell with the bottom half, facing in the same direction). I am saying this because if you use it the other way, upon opening the lid, the hotends fall out. ( also you tend to think the design is worthless, gets sad, even depressed, write a bad review and print a different model. And I do not want that:D)

This collection contains the following versions:

• With Bambulab logo:
  • AMS version: altough it can be printed with AMS, I would rather recommend the non AMS version due to the less waste it produce, and the cross coloring of the lighter filament.
  • Non-AMS version: print the box and the logo separately, and press it in place later.
• No logo version

THINGS TO KEEP IN MIND

/ Illustrations based on the bigger toolbox model /

• When closing the latch, it reaches is designated ‘closed’ state by deforming. If you choose to print it from a more rigid material you might need to file it to reach perfect closing. If you print it from a more flexible material like PETG, your print should work without any filing. If you find closing difficult, file the surface shown below.

• There are multiple overhangs where support used, but sometimes they are hard to spot. Pay attention to these places, because missing to remove support can cause headaches.

• The small parts on the photo above you can see small latches for the container covers. You can insert them by slightly bending the container covers ( gently:D)

If you are printing the models on non-Bambulab printers please bare in mind the following:

• Use support at the bottom part of the lock, at the inner cavity of the small enclosures lock and at the logo seating
• Prevent using any support on the hinges and on the hinge of the lock.
• Increase infill at the hinge section and its close proximity.