toilet paper holder for standard heater

This paper holder is designed and tested for a custom fit make sure that it would fit by printing fit fest on the first build plate to avoid wasting filament :) You can choose between 2 orientations, just delete the other one in the print profile.

In case you have a “ladder” heater in your bathroom, check my other models :)

 

The radiator should be 62 mm thick and should have a rim suitable for clicking the holder in. Again use fit test. The clicking in is a bit tricky, you have to find a good angle.

 

I purposefully lowered the printing speed for a better result, increase at your own risk.

Test printed with PETG. PLA is not recommended, because of the heat from the radiator.

Boost Methis model took me a lot of time, I would be very happy for your boost.