Rolex Wall Clock (011 kit)

MembershipIf you would like to sell prints of this model, subscribe to my commercial plan for only $3 a monthBoost MeIf you like what you see please boost me

Hello all! I am super proud of this model, I wanted a good Rolex clock to hang on my wall and I couldn't find one so I designed one myself. I hope you like it!

 

You can decide to print it in silver/black or just in black, either way it should look cool. I would suggest printing my print profile rather than the raw CAD files because it's hard to paint.

 

NOTE: The clock face is supposed to be a tight fit to the outer ring. This is meant so it can be pushed in and out for your preference.

 

Settings:

Initial layer height 0.1mm

Initial layer width 0.3mm

Supports auto

Brim auto

 

The smaller layer height is because the two bodies can be different colors, not sure for other slicers but if you use bambu studio and want to use multi color, make the initial layer height 0.1 and width 0.3.

 

How to assemble:

First place the two halves together and glue them at the seams. Make sure there is pressure at both sides to ensure there is no gap.

Note: It is way easier to do this step first.

Then put the clock face into the clock outer circle. This is designed to be an interference fit (tight fit) so you can push the clock face as far in as you want to achieve the depth effect you want like shown in the images.

 

Next insert the clock components kit into the back of the face and put on the hands in the order of hour hand, minute hand and then second hand. In order to assemble the second hand, cut off the two ends of the second hand given in the clock components kit and glue it to the back of your new printed second hand as shown in the images below:

Finally after assembling the hands on the face of the clock, be sure that none of the hands are touching each other or the clock face, put the battery in the clock kit and enjoy your new Rolex!!