Modular core Lightsabers V1 - Revan(Jedi) (MCL-V1)

Revan's Jedi Lightsaber Adaptation

This project introduces modular lightsabers that allow for the interchangeability of most components. It is designed to be compatible with various lightsaber core kits, including collapsible blades.

Types:

CORE:

• Compatible with Baselit/Neopixel lightsaber core kits.
• Features additional holes for the kit's buttons and screws.
• Can accommodate a standard 1-inch plastic/LED blade.

Collapsible:

• A simplified version designed to fit the included collapsible blades.
• Warning - The emitter's inner radius is smaller, making it incompatible with the 1-inch blade.

Important Notes:

• Interchanging components is possible with other MCL-V1 models.
• Some CORE/Collapsible parts are not interchangeable (e.g., Radiator/Emitter).
• Designed for a 0.4mm nozzle, with optimal printing at a 0.12mm layer height (threading issues may occur at 0.2mm).
• Intended for PLA; threading may become tighter with PETG, though still functional.

Parts:

There are various optional plates for each project.

Spikes:

• There are 5 total variations of the spikes (smooth/square/indented…).
• Installation:
  • First insert the small peg to the Handle.
  • Then, push until it is flush with the saber and close it with the Emitter.
• Optional:
  • Close them with a short m3 screw for additional strength.

Core Kit:

• The included M3/M4 screws in the core lightsaber kits are compatible with this model.
• The print is designed to withstand light dueling, but ensure all parts are tightly secured for the best structural integrity.
• There are 2 included Handle types.
  • Short - for a better appereance overall.
  • Long - for a more real representation.
• There are 2 included Emitters.
  • Default - 3D print adaptation (not supports needed).
  • Optional - Closer to read model (supports are needed)

Collapsible:

• The collapsible blades can be printed together at a 0.25 layer height or individually in vase mode (0.82-0.88 width).
• Two blade types are available: long and medium (A1 Mini compatible).
• Do not use the emitter model from the Core kit, as it will not hold the blades.

Extras:

• There are 4 additional handle spike types, all in an optional plate.
• Covatek dial, can be attached in 2 locations:
  • At the base of the handle.
  • !Core emitter only - at the top emitter retention holes.
• Emitter screw - needed in case the emitter tolerances are too tight and it is hard to close it on the spikes.