DIN Rail Arduino Uno and Mega Mounts

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that
has these form factors. The din rail clip can be attached temporarily to the
Arduino base using a piece of 1.75 mm filament. The clip can be attached
horizontally or vertically to the Arduino base. It can also be glued to the
Arduino base for a permanent setup. The clip shall be printed on its side. The
spacers shall be put between the base and the Arduino board, held by the
screws. Four or six M2.5 x 8 mm screws are required, but may be substituted.

Support material is not required. Nevertheless, the recess of the clip must be
clean-up to prevent breaking the Arduino baseplate. An infill of 20% is
recommended.

This object main web page is:
http://www.ctheroux.com/din-rail-arduino-uno-and-mega-mounts/.

This object was designed using Solid Edge Community Edition.

You can request the source files on the page listed above.