Dragons Breath Mosaic

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

Each plate of the model is 200x200mm in size for a total of 600x600mm. You can change the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Grey Transmission Distance: 1
PLA BambuLab Basic White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 7 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #9 (0.8mm) swap to Grey
At layer #11 (0.96mm) swap to White
At layer #14 (1.2mm) swap to Red
At layer #21 (1.76mm) swap to Orange
At layer #23 (1.92mm) swap to Yellow for the rest.

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!

MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!