Bambu Lab V1 Side Spool Holder P1P P1S X1 X1C

This has been updated with a Version 2 mount - Bambu Lab V2 Side Spool Holder P1P P1S X1 X1c Remixed by Simply Models - MakerWorld

I designed this to utilise the A1 Spool tensioner from the AMS lite to create a quick easy spool holder for the X1C.

It allows for smooth turns of the spool while holding mild tension on the filament.

Print file tested on Bambu's smooth high temp plate using Bambu ABS material. This has also been tested and works in PLA-CF. Likely other materials are fine but I've not personally tested them on either profile.

Please note the STL files & Profiles between ABS and PLA-CF differ to suit each material.

The first plate on the file is the side spool mount with dovetails so the AMS Lite 4in1 hub can be mounted above the spool.

The Second plate is the same mount but this doesn't have the dovetails to attach the AMS Lite hub bracket.

Fitting instructions; ideally use a threading tool to re-thread the M10 push fit fitting on the spool mount, this is a tight fit. It can be fitted without re-threading it with a little force. Be warned the AMS rotary spool holder once pushed on can be difficult to remove as this is also a tight fit. The AMS Lite bracket fits in reverse to how its printed on the plate, these can normally be pushed in place by hand depending on your filament calibration, if not you can gently tap them in place with a small hammer.

Where as the ABS profile print is fine and does the job the same, the PLA-CF profile and material give it an almost factory look to the print.

Many hours went into creating this and a fair few test prints have been done to create the perfect profile to get it too print correctly, neither the ABS or PLA-CF are standard BS profiles. I advise you print them directly for the best results.

Required items

First plate of this print.

1x M10 Through push fit.

2x 20mm M3 Countersunk screws

1x AMS lite Rotary Spool Holder (GREEN). AMS lite Rotary Spool Holder | Bambu Lab UK

Extras required AMS Hub extension

1x AMS lite Filament Hub. AMS lite Filament Hub | Bambu Lab UK

1x 12"Inch Bambu PTFE Tube.

1x Print of the AMS Lite Adapter Link on Maker World; https://makerworld.com/en/models/67779#profileId-71929 courtesy of SPStudio. This also requires an extra M10 push fit.