Working Turbo For 2-stroke, + active lubrication!

If you want to use it to run on an engine, I would recommend printing it in a high-heat filament. I used two ID-10mm, OD-15mm bearings on the shaft. The shaft that I used was 10mm in diameter. Lastly, for the engine's exhaust, I used a 9mm high-heat tube directly into the exhaust side of the turbo. Make sure to add two 10mm ID Orings between the turbines and the bearings, so that they don't rub. Added active oil lubrication with guide channels, to prevent friction and ceasing.

Boost MePlease boost me it helps out a ton. Check out some of my other models you might find something you like.
Thank you!