5 Port Hub for the Kobra 3

A short 5 port hub for the Anycubic Kobra 3. The cap may be a little difficult to snap into place on the first try, but it ensures that it won't come loose during printing.

Requires low profile collets, which can be printed from here:

https://makerworld.com/en/models/672203

You'll need to use at least 1 of the small clips for the center port, a regular one won't fit. Use the thickest clips that you can fit in order to create a strong grip on the tubes.

You can also use regular non-printed collets but they need to be low profile ones similar to what the stock hub comes with.

~Recommended print settings~

Layer heights: Maximum of .1mm, lower would be even better.

Outer/Inner walls order

Arachne Wall Generator

No higher than 60mm/s for the outer walls.

Make sure to orient both pieces to print upside down, no supports.

The inside MUST be smooth, if you see any defects in your print, you'll need to clean it up before use to prevent jams.