A1 AMS upper-mounted device- A1 AMS上置装置

This model has been redesigned. Please go to download the updated model.

MingGY | 已发布 - MakerWorld

这是为拓竹 A1 设计的 AMS lite 上置安装装置。设计简约牢固，采用 ABS 耗材打印。目前已在我的 A1 上安装使用超过 60 小时，毫无问题。
与官方发布的 AMS lite Top Mount for A1 相比，我的设计模型分件更少，打印时长更短，更易于打印，安装也更加简单。

所需五金：8 颗 3×12mm 自攻螺丝，5 颗 3×16mm 自攻螺丝。

推荐使用长度在 850 毫米至 900 毫米的 PTFE 管。

打印提示：为确保可靠的打印效果，推荐使用 ABS 耗材打印。使用 PLA 或 PETG 打印的结构强度未经验证，大胆尝试者希望在 500 小时后反馈装置是否牢固。为保证打印模型的结构强度，请勿在切片软件中改变首层面的朝向。

This is an upper-mounted installation device of AMS lite designed for Bambu Lab A1. The design is simple and firm and is printed with ABS consumables. At present, it has been installed and used on my A1 for more than 60 hours without any problems.
Compared with the officially released AMS lite Top Mount for A1, my design has fewer model parts, shorter printing time, is easier to print, and the installation is simpler.
 

Required hardware: 8 self-tapping screws of 3×12mm and 5 self-tapping screws of 3×16mm.

It is recommended to use PTFE tubes with a length ranging from 850mm to 900mm.

Printing tip: To obtain reliable printing results, it is recommended to use ABS consumables for printing. The structural strength of printing with PLA or PETG has not been verified. For those who are bold enough to try, it is hoped that you can feedback whether the device is firm after 500 hours. To ensure the structural strength of the printed model, do not change the orientation of the first layer in the slicing software.