Tape Hanger/Holder (Parametric)

Parametric hanger for your rolls of tape, designed to be stucked on the vertical surface with 25mm double-sided tape.

No support, prints on the side.

You can adjust the parameters in Fusion to generate a hanger for your specific needs, parameters are:

• TapeWidth - the width of the roll of the tame, as measured
• TapeWidthClearance - clearance added to the width, 2mm by default
• RollDiameter - the inner diameter of the roll, for big rolls it's usually 75mm
• LipSize - the size of the lip, that does not allow the roll to slip of the hanger, 5mm by default
• ScotchWidth - width of the double-sided tape used to stick the hanger to the wall, by defalt 25mm

The models for the sizes I found around my house are available: (TapeWidth x RollDiameter)

• 50x75 - the most common wide roll of tape
• 25x75 - also very common narrower size
• 24x75 - some rolls of foamy double sided tape are 24mm in width, but you can use 25x75 model instead
• 19x40 - electrical tape
• 19x32 - electrical tape
• 9x75 - Kapton tape

Embossed size on the top is generated with Parametric Text Fusion 360 plugin https://parametrictext.readthedocs.io/en/stable/parameters.html

You might need to install it, or just update the text manually.