This wireless headphone charger is inspired by classic turntable designs. When you place your headphones on the record, it will spin and lights inside the case will flash.
Customized your record label with Make my Sign.
All required parts are included in the Wireless Charger Kit linked in the Bill of Materials.
Printed Parts
Case Top
Case Bottom
Grill Background
Motor Gear
Coil Grill
Coil Holder
Record Holder
Button Array
Switch
Big Knob
Tonearm
Tuner
Small Knobs x3
Sides
Record Base
Motor Cover
Record Label (customizable)
Assembly
Please refer to the following video for assembly instructions.
No glue should be needed but you may choose to use it to hold the LEDs in place.
All required parts are included in the Bambu Wireless Charger Kit-K012 but you will not use all of the parts in the kit.
The coil grill is not required but is intended to ensure that the record doesn't rub against the charging coil. If the record is sticking, this can be removed.
Drive Modes
You can change the drive mode with the button on the back. All can be used but the mode that turns for a few seconds is the best fit.
Recommended mode:
Example of non-recommended mode:
Printing Tips
As indicated in the 3MF, I recommend printing the internals with a filament that can withstand higher temperatures such as ABS. Although I have tested this model with PLA, ABS will be less likely to warp under heat.
I used a textured PEI plat for most parts but a smooth plate for the base top - this is so that the front edge doesn't show any texture.
It is recommended to use the 3MF attached to this project as it includes the print settings appropriate for each part.
This test model was printed using an A1 Mini without AMS (and painted) along with an H2D with AMS.
MaKim
