Big Brick 600% Simple Locomotive

MembershipClick here to support me and to sell prints of my models!

Here we have a brick built simple locomotive scaled 6 times the popular brick companies standard size. Whats better is it requires no supports to print! The colors are just a suggestion based off the set it was derived from so please get creative and mix the colors up and show us your creations!

 

I printed the cab part (1x1 tile) in clear pla and used a concentric infill with extra walls to give it a more crisp look but feel free to change up for your needs.

 

Assembly is pretty straight forward. First insert the lens part into the main body of the camera part, then insert the small retention pin into the hole on the bottom. Note one end has more of an angle to aid with assembly however it will fit both ways. Next take the two plume halves for the smoke and partially insert the short pin in the bottom then the long pin in the back noting the angle on the pin. Then just push them in (they can be scaled down slightly if too tight). Everything else just presses on just like any other building block.

 

Thank you for checking this out and if theres any issues or questions feel free to message me!