Dimensions: 142mm x 139mm x 36mm (5.6" x 5.5" x 1.4")
Assembly:
Glue is not required, but could help if parts are loose.
Supports: The supports are pre-made and ready for printing
(optional) If you have Support for PLA or PETG material, then you can use those as Support Interface for “Sea Turtle Bottom Shell” print. Using the following settings will essentially print an easily removable support raft to print 90 degree overhangs on. The advantage is that is will leave the supported area smooth. Under the Support tab use these settings:
Support/raft interface: set to PETG or Support for PLA
Interface pattern: set to Rectilinear
Top interface spacing: set to 0.0mm
Top Z distance: set to 0
Material that I used:
Ziro Snow White (PLA)
Ziro Black (PLA)
Ziro Skin (PLA)
Ziro Green (PLA)
eSun Pine Green (PLA+)
Boost MeFeel free to message me with any improvement suggestions or design ideas.
BKPrint3D
