November 4, 2024
Description
This is a lightbox based on a picture i found on the internet of Spider-man's face, i thought it would look good as a lightbox. This would look great next to any type of comic or gaming setup collection. Any comic fan would love this.
I've also added in a stand to go with it if you don't to put it up on a wall.
Remember to remove the purge line. This is because of the size of the lightbox and the angle it is set at on the build plate.
I've already added holes to the back plate but you can just remove these by deleting them if you don't want them.
Bambu Studio
Just keep to my profile and all should be well. By all means please feel free to change it to your own liking. Here are my settings:
Plate Type - Textured PEI Plate
Quality - Elephant Foot Compensation - 0
Quality - Arachne - Default settings
Strength - Bottom Shell Layers - 5
Strength - Internal Solid Infill pattern - Monotonic
Strength - Sparse infill density - 5%
Strength - Sparse infill pattern - Gyroid
Speed - Initial Layer - 25mm/s
Speed - Initial Layer Infill - 50 mm/s
Others - Brim Type - No Brim
Others - Brim Width - 1
Putting the lightbox together
I tend to use aluminium tape for the back plate, this is so it can reflect the light better. I use super glue and an activator spray, but i am very careful to watch how much super glue i put on it, if there is too much then it can dribble over the edges and when it dries it will cause a white mark. I tend to use these lights 5V USB Led Strip Light SMD 2835 50CM 1M 2M 4M 5M White/Warm White/Red/Blue/Green IP21 Flexible Lighting Ribbon Tape Backlight - AliExpress 39 in the lightboxes i do. When putting the lights in, try and keep about half way along the wall, too far back and it will get in the way of the back plate when you glue it in place, too close to the front and the effect with the lights wouldn't be as good.
Any questions please message me.
License:
BY-SA
Clansman
