解压玩具 变形斩斧

可以丝滑变形的双形态武器——斩斧

拥有剑形态和斧形态，承载着男人梦想的浪漫变形武器

是我心中最帅的武器

原型怪物猎人中的斩斧武器专属图标，现在它变成了可以自由变形的钥匙扣，丝滑又解压

如果喜欢的人多考虑做一个多色版本！（并尽量让没有ams的也可以打印）

多色版本已经制作完毕，不用ams也可以手动分色暂停打印

而且可以甩着玩了~

做了好多版，终于完美了Σ_(꒪ཀ꒪」∠)_

求求卡普空荒野加强斩斧！！！！试玩版里太弱了

为我助力感谢喜欢~

安装教程：

如果没看懂可以看我发在b站的视频：

安装需要用到美工刀和透明胶带

转轴使用的是耗材丝，如图：

1. 拆除支撑，建议用美工刀分离支撑与模型，然后把支撑拽出来

2. 如图将剑与手柄的圆孔对准，然后插入一段耗材，注意插入方向。将耗一面按在桌子上，用美工刀切除多余耗材（不用担心耗材不能得到完美长度，有预留的空隙）用透明胶带粘贴两侧，尽量与手柄长度相同

3. 将剑旋转到上图位置，然后先把斧子上的齿条卡入，然后再卡另一侧，最后扣上盖子（卡不上请检查支撑是否拆除完全）

如果你的斩斧滑动卡顿，可能是卡的耗材过长，可以试试调整盖子的松紧：

Installation tutorial:

Installation requires the use of an art knife and transparent tape

The shaft uses consumable thread, as shown in the picture:

1.Dismantle the support, it is recommended to use a utility knife to separate the support from the model, and then pull out the support

2.Align the sword with the circular hole on the handle as shown in the picture, and then insert a section of consumables, paying attention to the insertion direction. Press one side of the consumable onto the table, use a utility knife to cut off excess consumables (don't worry about the consumables not being of perfect length, there is a reserved gap), and stick both sides with transparent tape, trying to match the length of the handle as much as possible

3.Rotate the sword to the position shown in the picture, then first insert the rack on the axe, then insert it on the other side, and finally fasten the cover (if it cannot be inserted, please check if the support is completely removed)

If your chopping axe slides and lags, it may be due to excessive consumables. You can try adjusting the tightness of the lid: