Big Brick B1 Battledroid 500% no support

Roger Roger! This brick style B1 Battledroid prints with no supports and assembles without the need for glue with a well calibrated print. Its as fun to assemble as the popular bricks that inspired it! Hope you enjoy it!

Like this droid? Check out my other droid models!

To assemble,

Use the two short and two long pins and insert them as shown into the torso halves. Long pins on top

Then take the “v” shaped portion of the head and insert the larger two of the three pins into the cavities as shown. Next take the top of the head and align it to the pins.

Insert the two round parts in each side of the head to lock them together

Take the clip portion and insert the “d” shaped end into the palm and slide until fully seated. Top of the pin will be slightly lower than the palm

Slide the top onto the bottom and use the smaller pin to lock them together

There are two versions of the arm, straight and bent. The upper portion is slightly different and marked with an “s” for straight and “b” for bent. The lower arms will not work on the incorrect arm. Simply slide the top and bottom onto the elbow connector and then place the cap on the top. These connections are pretty snug to keep the arms more rigid.

There are multiple versions of the blaster that i will be including with various models but they all assemble the same. Place the two halves together, start the short pin in the grip and then the long “stock” pin in the rear then seat all the way in.

Thanks for checking this out and happy printing