Oculus Meta Quest 2 Strap Cable Holder

This is a remix as the one I printed was for the elite strap and I found that it would easily come off of the standard strap. So I adapted it to fit the standard strap. Works great so I thought I would share :-)

Simple cable clip for the Oculus / Meta Quest 2 Standard Strap. Designed around the official Oculus Link cable, but will work with others. the Cable in the picture is an aftermarket one that also powers the headset in use. I also have the standard cable and it works perfectly with both.

I hate the cable dangling and hate just QR cable tying it on.

I have printed it in PLA+ and it works perfect! 15% infill too.

1 x clip uses 2.39g and takes 12m 31s on the P1S

2 x clips uses 4.69g and takes 16m 47s on the P1S

I liked two clips. One on the side and one on the rear so the cable goes more down my back, but one or two is fine :-)

Enjoy.

*** Side note - I have also tried it on the Quest 3 strap and it also works on that. The Quest 3 strap does appear to be a couple of mm's taller than the Quest 2 Strap though. I will do a bit more test and maybe make one “perfect” for the Quest 3 :-) ***