Default Head rotation +90 deg for single extruder filament swap for new extruded face option (FACE_EXT ver).
Modified how built-in supports work, this should allow for easier removal (NO_SUP ver).
Added a version that needs support for a better overhang on the upper legs (SUP ver).
UPDATE 5/27/2024:
New version with a standard .3mm tolerance between joints. When I received my A1 and used out-of-the-box settings, I noticed joints were hard to move, so I've added a new version with a .3mm gap to help with breaking apart the joints.
Printing:
NOTE: This model was designed with a .4mm nozzle in mind, other sized nozzles may not work. Scale at your own risk.
Printed at .2mm layer height with 20% gyroid infill and 3 walls.
Use the default orientation.
FOR Creeper_NO_SUP and Creeper_NO_SUP_FACE_EXT
Supports are not required, this version will have worse overhangs.
DO NOT repair the model; doing so will remove the custom supports, causing the legs to print fully in mid-air.
Turn off Detect Overhang Walls.
FOR Creeper_SUP and Creeper_SUP_FACE_EXT
Print using supports.
Only needed under floating legs, paint-fill overhang.
Tree and Snug work well.
Clean Up:
After printing, the head and legs should snap apart, allowing them to rotate freely.
Be careful not to apply too much pressure when releasing the joints.
You can also print the optional Creeper face and use super glue to adhere the pieces (for Creeper_NO_SUP and Creeper_SUP).
Delphant
