Mini Putting Golf

I saw this model on Thangs but didn't want to pay for it, so I made one myself. The large piece is meant to go at the end of the table or desk. To make the actual golf club, stick a pencil in them. It is quite loose, so wrap just a tiny bit of tape around it, and it will stick better than before. I used average Ticonderoga pencils. for the golf balls, I used marbles that were 1.6 cm in diameter.

all credit goes to: https://www.thingiverse.com/thing:5872415, for the golf clubs.

print settings:

infill: tri-hexagon. 20%. 

print speed: 60mms

walls: 3 walls. normal

filament: CR-PETG

(Creality official)

• Additional print settings would include no bottom layers and a print temp set to higher on the bottom layer. There was no need for PETG.