Butterfly

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

 

Filaments Used:
PLA BambuLab Basic Gold Transmission Distance: 6
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Gold
At layer #14 (1.2mm) swap to Black
At layer #19 (1.6mm) swap to Blue Gray
At layer #21 (1.76mm) swap to Jade White for the rest.

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!