Beautiful Flower Puzzle by: @JufJoni :Remix

SPECIAL THANKS TO: Creator @JufJoni for making a really great puzzle! 

I just made a few alterations to make it easier for young ones to use. 

Base, Leaf, and Petal have notches to remove pieces easier. Smoothed out a few corners. 

Note: Parts in this remix may not fit original model.

As seen in attached pictures, made petal uniform so they would fit in any orientation. 

Chamfered edges to make it less sharp.

Made one Stem Leaf that will fit either side. ( Print one “X mirrored” if you want print patterns to match, although not necessary unless your print bed leaves a different pattern on the bottom layer that looks different from the top.

NOTE: Picture of my competed print was printed prior to making Stem Leaves uniform.

Layer Height 0.2, 5% infil, PLa, PETG

Green Stems and Leaves color is called “Fresh Poison”.

No Support required.

Use at your own risk and with supervision, Potential Chocking Hazard.

TIPS TO PRINT FASTER BAMBU STUDIO:

Just in case you weren't aware, in Slicer, If you select “Special Mode”, “Print Sequence”, "By Object" you can print multi color components Much faster with Much less waste as they will print each group of the same colored objects fully before moving to next object, as opposed to switching filament each layer.

For each part of the same color, (like 4 petals), arrange them closely, hold down shift key, drag over objects, right click and select merge. This will allow closer barriers in “By Object” mode between different color parts. I printed the entire project on two plates in 2 ½ hours.

God Bless,

Casey 

@BowieInc