Strong Snap Buckle - Double ended (Harness) 25mm

Remix of the very good - Strong Printable Snap Buckle.
Remixed to be used as a Harness. With a double end Female connection with a buckle at the bottom to feed 25mm straps into.

This is to convert the Snap buckle into a harness.
To print all without supports. The bottom 25mm strap feed is facing the other way, so the strap will tighten on the inside, instead of the outside.

Print profile updated to add an extra wall (3 → 4) as well as Gyroid infill.

Printed using PLA+
However ABS would be more suited.