Adapter for small spools. AMS.

Boost Me

The adapter is designed for use with small spools in AMS systems (not tested for AMSLite!).
 

If you wish, you can thank me here:   https://ko-fi.com/bambas  and I will try even harder.
 

Changed: The design has been improved based on recommendations from comments.
1 - The width of the side edges has been reduced to about 5mm.
2 - The minimum width, with the adapter screwed in all the way, has been reduced to about 10mm (now there is no need to print an additional ring :-P)
Thanks to everyone for the tips, I tried to correct all the errors.

With an outer diameter of 200 mm and an inner diameter of 51 mm, the width fits spools from a minimum of 35 mm to a maximum of 59 mm.
Personally, I use it to test new filament so as not to buy large quantities, I buy 200-250 grams.

Changed: Three width straight and angled spacers added to the project for centering the spool. 
Please check the dimensions before printing the project!!!

!!!   Check your spool parameters before you start printing a given project   !!!