X1C Simple Slim Waste Bin

Simple slimline waste container to allow space (approximately 2 Inches) for the AMS on the Left. It has a separate base plate that slots into the bottom edge moulding at the rear of the X1C printer. The waste basket locates on to the base to prevent movement whilst being still easy to remove when full.

To install the base, carefully tilt the printer, lifting the rear to allow the slotted base plate to fit as shown the photo, the basket should then easily locate on top of base.

Note: The main waste bin is slightly slanted to allow an optimal fit to the base. It will not fit correctly if the base is not used.

I think this will also fit the P1P but haven't tried it.