Bed Handle V2 for use with A1, P1, X1 Printers

UPDATE 2/19: NEW V4 OUT! https://makerworld.com/en/models/1127187#profileId-1126794

 

This is an updated version of my previous handle design (https://makerworld.com/en/models/830474#profileId-774711)

 

It's much stronger, can be used with Generic or Bambu plates alike, and much easier to assemble. It is a single piece design instead of a clamshell assembly. It also uses screws instead of nuts. Finally, it's very thin for use with the P1 and X1 with closed doors.

 

I designed this to give you a secure place to grab your plates that won't result in you accidentally touching the build surface. It should also help those with limited dexterity that would like a more solid grip on their plates.

 

For installation, simply slide the bed into the grooves and tighten the screws down. Turn the screws by hand until they get hard to turn and then use a wrench or pliers to tighten them down another half turn or so. Do not overtighten or they will break.

UPDATE: Added Heavy Duty variant. Twice as thick and grips the board a lot stronger if you don't mind the extra filament and weight.

 

Boost MeDrop a boost if you love it!