Trash Bag Holder (Extra Large) - No Supports

The model was created because I needed a trash bag holder big enough to hold the extra large rolls of trash bags from Sam's Club. 

This XL Trash Bag Holder is designed to be used vertically. I added additional keyhole slots to test the model horizontally; HOWEVER, after printing and trying it horizontally I could see it bend with the weight of a new roll (see last photo), so keep that in mind. I will try to work on another version that doesn't bend when used horizontally.

GENERAL INFO:

• No supports needed. I have added removable tabs to act as supports for the bridges of the keyhole slots. If you get a message about floating regions in the model, that's what it refers to and they shouldn't be moved or removed. After printing the model, just snap them off.
• Inside Measurements:
  • Diameter: 178mm (7 inches)
  • Height: 229mm (9 inches)
  • Thickness: 2.5mm
• The bags pictured are Sam's Club's Members Mark 13 gal. A new roll contains 100 bags and measures 171mm x 223mm approximately.
• Filament: BambuLabs PLA Basic Sunflower Yellow (10402)