18650 battery case_2s_3s

.大电流可以用电烙铁焊接至少18awg线.我测试非焊接,20A大电流热熔耗材
.顶部窗口方便观察电池或者穿梭扎带
.底部窗口可以方便挤出电池,当然左右也开了窗口,方便取出电池
.不装电池弹片也可以存放电池
.没有晃动使用场景,可以不打印盖子
.尽可能适配平头和尖头的18650电池,安装后不太紧,不太松
.所有孔都可以用m3沉头螺丝,相连或者固定在木板上
.左右可以m3X6沉头螺丝相连.比榫卯结构稳定,但我觉得没必要,麻烦.有需要更多电池数量的评论区留言

--------------------------------

.High current can be welded with a soldering iron with at least 18awg wire. I tested non-welding, 20A high current hot melt consumables
.The top window is convenient for observing the battery or fixing the cable tie
.The bottom window is convenient for squeezing out the battery, and of course there are windows on the left and right to facilitate the removal of the battery
.It can also be used as a battery storage box without battery shrapnel
.There is no shaking usage scenario, the lid can be omitted
.It is as suitable as possible for flat-head and pointed 18650 batteries, not too tight or too loose after installation
.All holes can be connected or fixed on the board with m3 countersunk screws
.The left and right can be connected with m3X6 countersunk screws.It is more stable than the mortise and tenon structure, but I think it is unnecessary and troublesome. If you need more storage space for batteries, you can leave a message in the comment area