Heights - minimalist clock

Boost Mehuge thanks for every boost!

About the model:

A minimalist clock with minimal assembly needs. You only need to do 3 snaps and it's done. No gluing or screwing is needed.

 

This design doesn't make sense in a smaller version. Sorry, A1 mini owners.

 

Print info:

Designed for printing with 0.2mm layer height.

Make sure to have a perfect bed, free from dirt and bumpy areas. If there are no first layer issues, it is a very easy print.

Epic surface quality is achieved with the genius ironing settings of @moontiger3d. If you have problems with it, turn it off.

 

Assembly:

1. Print both plates.

2. Remove the support from the area of the blue cube. Make sure not to leave any support material on the circular surface marked with red!

3. Take the main mechanism from the Clock Components Kit and snap it into the slot on the bottom side, aligning the battery part with the ‘+’ and ‘-’ signs.
4. On the top side, slide the hour hand (short one) onto the corresponding shaft until it doesn't go further. It should only need a little bit of force.
5. Do the same with the minute hand. There should be a small gap between the two hands in the end.
6. Set the time and hang it.

 

Commercial License:

MembershipClick the 'Join' button to subscribe for Commercial License Membership