Float Shell for Magnetic Levitation Kit

This is a case to the float piece that comes with the Bambu Lab Magnetic Levitation DIY Kit. Only needed if you need a replacement case to the provided one in the kit.

Highlights

• Holds the float components
• Print profile for convenient and customizable printing of the shell through Bambu Handy/Studio

Required parts

• Bambu Lab Magnetic Levitation Kit

Assembly instructions

1. Insert the spacer piece between the coil and the board

2. Place the magnet into the spacer

3. Drop the board/magnet/spacer/coil stack into the float base piece

4. Carefully (to not break the wire), seat the top of the board into the bottom of the top lid piece

   1. Make sure there is enough room for both wires to fit in the indent

5. Carefully (to not break the wire and crush the board), snap the top lid over the base
   1. The wires should be tucked along the gap
   2. Make sure the tips of the board stay in the indents

Printing notes

• Printing the top lid with a translucent filament may help highlight the indents and the tips of the board for easier assembly