Lawn Mower Cup Holder Mount

This is a cup holder for your lawn mower, or anywhere else you can think of, as long as it fits a 25mm rail! It has designed to be mounted to the side bar of a lawn mower specifically though.

A few notes:
The hex design cup holder sits at 45 degrees, but I have since redesigned the cup holder, so the other one sits at 40 degrees to be more straight up and down. If someone requests a cup holder that is straight up and down, I can make that happen as well, just let me know.
Also, I would recommend warming up the nuts when you go to insert them in their spot, as they are a bit snug and can crack the mount.

The hex design cup holder can hold most beverages, including those in slim can brumate coozies. However, the new cup holder was designed to fit normal sized Brumate coozies, so it is a bit wider.

To install this you will need the following:
8 - M4 nuts
8 - M4*18 or M4*20 screws (you can use M4*16 - M4*25 but 18s and 20s work best)

Designed to be printed with no supports. Recommend 20% infill or better.

If you have suggestions/improvements, I am open to hearing them as this is my first design!

EDIT: Realized the lawn mower cup holder had an issue printing due to the geometry being off. I have since redesigned it so it prints good now