Lantern

Boost MeThank you for any support

Informations
 

I printed all parts at layer height 0.20 mm.

Instructuctions
 

What you need?

All you will need is a screwdriver for printed screws. Screwdriversl 0,4x3

Step 1

Put wall infiling inside grooves. As pictured below.
 

 

Step 2
Put frames or decoration frame inside grooves. Like on photos. (in the links below you can found some motives)
 

Step 3
Once you've completed steps 1 and 2:Place the top lantern part on the top main platform and then attach it with screws. As per photos.

 

Step 4

The last step is to secure the roof. Take the roof and put it on the top part. After that adjust till it fits into the space (see on photos), turn with roof left 180 degrees to secure.
 

 

You've completed the setup of the lantern. Now you can put light inside. You can use a Tea Light Candle or Remote Controlled Puck Lights. If you use Tea Light Candle put it in the candle holder (photo 1) or if you use Remote Controlled Puck Lights place on puck platform (photo 2). After that take it and on the underside push it up and turn right 45 degrees (photo 3). (Tea Light Candle or Remote Controlled Puck Lights you can buy on bambulab store)

 

 

Links:
https://makerworld.com/en/models/859158#profileId-808989