Desktop photography multifunctional mirror car The chassis and wheels are printed with PLA, and for the axles to ensure toughness, it is recommended to use PETG material. Through physical testing, the practicality is very good, and it can meet the small-scale use of various photography and lighting equipment. Special attention: The bearings used for the wheels and the nuts used for the shafts should be embedded inside the relevant parts using the temporary function of the layer to ensure integrity. When installing the wheel, the top surface of the bearing inside the wheel should be flush with the end face of the axle to prevent the wheel from rotating smoothly.
List of other required accessories: Nut: M5 (thickness 3.7-3.9mm, tooth spacing 0.8mm, opposite edge length 8.75mm, diagonal length 8.79), 2 pieces Screw 1: M5 * 20 (screw data in the picture: umbrella head screw, head diameter 11.5-12mm, head thickness 5mm, umbrella head step thickness 3mm), 2 pieces Screw 2:1/4 camera specific screw (screw head diameter 12mm) Bearing: 608-2RS, 4 pieces Gasket: Nylon M6 * 10 * 0.5 (installed on the contact surfaces of each component depending on the situation) Wheel rubber band: outer diameter 50mm, wire diameter 3-5mm
Fhitman711
