Tealight holder with stand

A decorative tealight holder with optional stand. Inspired by my plant pot with stand, using the same design.

The stand and pot are printed separately and easily fit together. The to pieces of the stand should slot together without the need for glue. A very small amount of support is used on the lower edges to improve the quality of the bevelled edge. Variable layer height is used to reduce the layer lines on the rounded edge.

I've made two profiles for printing, the standard profile will print on separate plates, and the other profile allows them to printed on the same plate with ‘print by object’ switched on. Therefore only a single filament change is needed and the model prints in under one hour.

If you like the design, then check out my plant pot with stand here:
https://makerworld.com/en/models/860078#profileId-810165

Or here:

https://makerworld.com/en/models/869828#profileId-821600