LEG0 Like Brick Minifigure Display Stand

I have been using the official LEG0 ones and have been annoyed by the loose fit of minifigures and them falling over.

This has a tighter fit and should allow figs to sit snugly on your display (I tried to find a compromise between too much stress on the legs and a snug fit). Tested in PLA and PETG. No support is needed.

 

Two versions: “Looser Tolerance” which is tighter than stock but very conservative if you are worried about expensive figures and the standard one which is nice and snug.

The print profile has two plates, one print by part and one print all at once, if you are worried about stringing use the print by part one.

Boost MeBoost me for free if your minifigs found a new home