MembershipGet a commercial license to sell physical prints of my 3D models! Join my membership today and start profiting from high-quality designs. Don’t miss out on this chance to turn my models into your business!
Watch out everyone! There have been sightings of a potential Santa imposter roaming around.
People describe him as green and hairy and there are rumors it may be The Grinch!!
The Grinch uses push-fit connectors instead of my usual slide connectors.
In order for The Grinch to stand, I have created a multi-part base that is integrated into one of the legs.
Printing Tips:
Elephant foot compensation set to 0 for better adhesion between colors
Wall generator changed to Arachne and transitioning threshold angle set to 20
Reduce infill to 10% and change to Cross Hatch
No brim or supports needed
Assembly Overview:
Snap all connectors to free each individual piece
These should come apart easily but for the cleanest finish, it is recommended to use snips
Slide the Right Arm post through the corresponding hole in the Body
Due to print orientation, these posts can be more fragile than other pieces, so be careful when handling to avoid them breaking.
Snap on the Left Arm to that post
Repeat steps 2& 3 for the Legs
Slide the two small Base Connectors onto the corresponding cutouts on the bottom of the Right Leg
Slide the large Base Connectors onto the corresponding cutouts on the two small Base Connectors
If you'd like access to exclusive designs not available anywhere else, like the one below:
designs.by.Marcum
