AMS Feeder Saver Button

Simple trim on the edges of the button feed by @just_Josh's “AMS Feeder Button with optional PTFE” support to work with @Madizmo's “AMS Saver V5” guide. See (Photo 2) for clearances and compatibility between the two files.

Installation is the same as the original Feeder Button but if the AMS Saver has been installed, you may need a pair of needle nose pliers to encourage the AMS button to move over to lend enough room for the front (closest to front) of the original button. See (Photo 4) for how i had to orient it before it was installed (Photo 3). As the print orientation is also on its side which allows it to be a bit stronger but at the cost of a little bit more material for support (See photo 6). I have not installed the PTFE tube to enter through both the Button saver and AMS saver and had left it only in the AMS saver. If i do have issues with feeding due to smaller diameter rolls/ emptier rolls. then it may be worth while extending the PTFE into both units.