Magnetic Frother Holder

I made a simple magnetized holder for a generic frother accessory available on Amazon that attaches to the side of my Barista Express. The design holds two 10x2mm magnets, which is just enough strength to support the weight of the device. With a 30mm wide opening it should hold pretty much all of the generic devices available on Amazon, they all appear to be the same manufacture but rebranded. I enjoy using these types of devices to mix drinks but I did not want a stand that sits on the counter because they tend to get knocked over or be in the way... Printed in Bambu PLA with supporters enabled only for the magnet cavities.