Printer Side Panel Honeycomb Storage Wall

Boost Me

I ran out of space on my wall and decided to make a HSW for the side of my printer.  I have a P1S, but my understandng is the X1C has the same outside dimensions. I have no way of knowing if it will work with other printer models. It covers the whole side and is held in place by the feet of the printer. The goal was to use all the available space and not have it flopping around everytime I took something off the wall. I found that the top liked to tip forward a little, so I added a couple small clips to hold it back.  You may need a little sanding on the center of the two spots the feet go if they dont slide over the feet all the way.

 

To avoid breaking the two top clips you should install the top and bottom halfs of the panel seperately and then connect the centers.

 

Many thanks to rostap for his work developing the Honeycomb Storage Wall: https://makerworld.com/en/models/22521#profileId-27457

 

You can check out the full collection of my HSW models here: https://makerworld.com/en/collections/2834902