This model can be printed without supports. Before starting the print, it's recommended to clean the heated bed thoroughly or apply glue to improve adhesion, as some small parts may have difficulty sticking to the bed, potentially leading to print failures.
For this print, I used official filament from To Bambu Lab PLA. I’ve designed with proper clearances, but other third-party filaments haven’t been tested yet.
STEP 1:
Each thin sheet is marked with a corresponding number. Insert them into the base in sequence
(following the order will make the assembly easier,When assembling, be sure to apply pressure mainly on the rear end of the sheet.)
WEIWAY
