Mimiron's Head (Maglev) - WOW

----2025.1.5 Update

• Slightly increased thickness of the propeller attachment ring to reduce the risk of deformation of some consumables due to too much tightness during installation.
• Add ear pieces that hold both sides of the KC005 magnetic light.
• Add base center cap, Alliance and Horde version.

The magnetic levitation version is fully re-modelled and is easier to print and install than the fully movable version.

The magnetic levitation version uses magnetic levitation kit ZC008 and the blue magnetic light KC005, the LED light version of the base (if you don't have a magnetic levitation kit you can use this) uses the LED lamp MH001.

About Print Profile:

• The end of the body and the chair are pre-supported, no support is required for the other parts.
• PETG or PLA is fine for Mimiron's Head, PETG is recommended for the base as it needs to withstand higher temperatures.

About Assembly:

• See the installation manual for assembly of Mimiron's Head and the magnetic base. The rune in front of the magnetic base is the light switch.
• All slots have been optimised and normally no pre-treatment is required for the assembly process, but tolerances vary between filaments, so whether to sand or glue or not will depend on the situation.
• Magnetic Light Blue - KC005 is an optional, not a must.

• If you don't have the magnetic levitation kit, you can also use the LED light kit, the LED light version of the base installation process as shown in the picture: