Hepa Filter for X1/X1C/P1S

Boost MeIf you like these models please toss me a boost, thank you!!!

A rear external HEPA filter attachment for the back of the X1/X1C/P1S.  Uses 2 80x40x15 mm HEPA filters that can easily be purchased on amazon this is the one I used but they can be found all over.

 

https://www.amazon.com/dp/B0782T7L6P?ref=ppx_yo2ov_dt_b_fed_asin_title

 

The filter attaches easily to the back of the bambu printer directly over the exhaust fan with 4 10x3 magnets.  Since I also print abs/asa with my printer and currently use an exhaust hose attachment to port the fumes outside when printing those materials.  I designed it to fit over the exhaust alignment adapter made by eric_b found here https://makerworld.com/en/models/697655#profileId-626721.  This allows me to use the HEPA filter when printing in my house which is most of the time and easily swap it for the outside exhaust port I use when printing asa/abs when its in my garage.  The adapter is not required and the magnets will hold it securely in place with out it.

 

To keep the lid in place nice and snug just push the back of the HEPA filters forward a small bit to lock the lid in place.