怪物猎人斩斧 变形武器钥匙扣

禁止无授权贩卖！

 

⚠️ 版权声明 ⚠️  
本模型仅供个人非商用打印。禁止搬运至其他平台或用于商业销售，支持劳动成果，尊重知识产权！

 

可以变形的双形态武器~

根据一下参考图重新制作的，感谢插图的制作者~

这个版本是有勾勾的是斧，多边形的是剑，并且有更长的滑轨，安装方法也更简单~

提示：请使用0.2层高，并不要更改成其他高度！

Tip: Please use a height of 0.2 and do not change it to any other height!

在介绍的后面有组装教程，请不要因为没看到打差评，谢谢啦！

There is an assembly tutorial at the back of the introduction.,Please don't give a bad review because you didn't see it, thank you!

Boost Me喜欢的话谢谢支持！

分为两个版本：单色版和多色版，因为想让单色和双色都很帅，所以两个版本的模型数据不一样，给单色版做了浮雕效果，可以参考下图（单色版建议用灰色打印）：

 

组装教程 Assemble tutorials：

0.先从耗材上减下一段作为转动轴。Subtract a section from the consumables as the axis of rotation.

1.拆除支撑，建议使用美工刀辅助切割！Remove the support, it is recommended to use a utility knife to assist cutting!

2.将剑刃和手柄上的孔对准，在其中插入一段耗材丝作为转轴，不要切太长，否则会卡住斧子而不丝滑！之后用透明胶带粘贴两侧堵住孔使转轴不会掉下来。Align the blade with the hole in the handle, insert a piece of filament wire into it as a hinge, don't cut it too long, otherwise it will jam the axe without being silky! After that, use scotch tape to glue both sides to plug the holes so that the hinge does not fall off.

注意图片标记的位置，不要安装反了！Pay attention to the position of the image marker, don't install it backwards!

3.按照下图的位置卡上斧子，注意此时应该先将齿条插入手柄与齿轮咬合后再扣上另一侧，最后拼上另一半斧子。According to the position of the figure below to card the axe, note that at this time, the rack should be inserted into the handle and the gear bite first, and then buckle on the other side, and finally put on the other half of the axe.

EX.如果您使用了创客宝库中的钥匙扣组件，可以将圆环套到斩斧的手柄上，带着它一起去外面狩猎，并炫耀它炫酷的变形！If you use the keychain component from Maker's Supply, you can attach the ring to the handle of the axe, take it out hunting, and show off its cool transformation!