Jet engine nacelle extruded front

This is a remix of the nacelle (https://makerworld.com/en/models/603740?from=search#profileId-526340) made by simocia for the 3D printable jet engine(https://makerworld.com/en/models/13806?from=search#profileId-129851) made by CATIAV5FTW.
 

I extruded the front of the nacelle as I found the original to be too small for my liking, I also find it more realistic when extruded. Additionally, I changed the colors of the Rolls Royce badge to black and gray as it seemed nicer to me. The colors however, can easily be changed in the Bambu Slicer by clicking on the badge and pressing “n” to paint the model to your desired liking.

Finally, once printed I glued the two big parts nacelle together using super glue, I screwed on the the part at the back and then attached the the nacelle to the engine with the two screws I had left over from the build. This can be seen in the image with the 2 screws visible on the left side, one above and one below the front fan. Finally, you can glue on the the extruded front bit using super glue, and also the badge. That's it, it's finished!

You can display the engine using the display stand that I made for it here: https://makerworld.com/en/models/1037646-stand-for-jet-engine-with-nacelle#profileId-1021836

Additionally, if you would like to upgrade your engine and make it spin and work just like the real thing you can use my upgrade found here: https://makerworld.com/en/models/1723826-motorized-jet-engine-upgrade#profileId-1830031