Tacticool Unicorn (Bolt Action Blastercorn)

I thought it would be funny to turn the Xshot blastercorn into a bolt action “sniper.” The breech and bolt are drop-in, while the stock will need some shell cutting on the bottom to fit. Needs 0.5 - 1 cm of ½ in brass, 9 mm ID 11 mm OD O-ring, about 10 cm of 17/32 brass tube for the barrel, and a lot of lube. To install the dead space filler, insert it into the plunger head and superglue it.  To attach the stock, cut a 1 cm by 2 cm rectangle in the bottom of the grip and clear out any extra plastic that might be in the way. Secure the stock with hot glue. To attach the rail, find the middle of the blaster, drill holes where the rail has holes, and secure it with mlok bolts and nuts or m4 nuts and bolts. To assemble the breech, place the ½ in brass onto the bolt and secure it with super glue. Then take the breech cap and put super glue on the skinny portion, then inset over the ½ in brass. Next, pout the o-ring into the slot at the bottom. Then take the 17/32 brass and chamfer the side that will be interacting with the bolt. Then put super glue on the barrel and twist it into the horn. Then lube up the bolt and you should be good to go.