Mini airplane 12.0 - Jet Fighter

Version miniairplane 12.0 this time in the shape of a fighter.
The wings must be printed on 3 layers for better strength, so the first layer is set to 0.12mm and the next layers to 0.08mm. This setting has worked for me several times.
The inner fill of the model is set to 20%. 
Before removing the model from the printing mat, wait for it to cool down, the miniairplane is easier to remove and the wings will not be crooked.

if the back part won't go in, use scissors and trim the pin a bit, use a drop of glue for better strength, but not necessary

 

be careful with the cool plate, it is very difficult to remove
You can also use the included launcher

 

For the launcher, you can also use a coarser rubber

 

Check out my other models: https://makerworld.com/en/@Marek69

 

Boost MeIf this model inspires you, I'd be happy for a boost