Ice Fishing Transducer Arm

This pivoting arm holds your transducer over the center of your fishing hole to prevent it wearing or freezing to the edge of the ice. Designed for the Helix 5 and 7 Ice Fishing Shuttle (407066) and the Humminbird Ice 35, 45, and 55, but can be easily adapted for other setups.

Note: Installation on humminbird Ice Shuttle Requires Drilling a Hole

Mounts using ¼" Hardware

Suggested Hardware:

1- ¼" x 1" Hex Bolt

2 - ¼" x 1.25" Hex Bolts

3 - ¼" Nylock Hex Nuts

2 - ¼" Washers (Optional)

Mounting Instructions (407066 Ice Shuttle) Refer to last 2 photos

1. Insert one of the ¼" x 1.25" Hex Bolts in the edge mount from the bottom
2. Position the Edge Mount where desired and use it as a template to drill a hole (Suggested location in photos) Make sure the recessed hex hole is on the outside
3. Insert other ¼" x 1.25" hex bolt through mount and newly drilled hole, secure with nylock nut on the other side
4. Place the washer, then the longer of the 2 arms on the bolt one top of the edge mount, secure both with nylock nut
5. Use the remaining ¼" x 1" Bolt and nyock to secure the shorter arm, placing the washer between the two arms
6. Tighten to desired friction