Old watchtower terrain RPG Dungeon and Dragons

Boost MeIf you like my work, thank you for your support.

 

Old watchtower.

 Perfect element for almost any RPG or fantasy game. The tower is very easy to print, does not take long and looks beautiful. The print is divided into 3 parts after printing they should be glued. Some of the elements are quite small so please be careful when removing the supports. I recommend following the instructions below.
 

Old watchtower
40 mm wide by 99 mm high.

 

Printed in bambulab pla basic- gray filament.

 

Please note that if you use a different filament than the recommended one, the effect may be different from my print. For example, printing in silk PLA will look better but the supports and the print itself will be more brittle and less durable.

 

Recommendations:

 

The print is set in an orientation so that the legs adhere perfectly to the board, and you can also add a brim.
When removing the supports, I recommend first cutting off the pieces right next to the miniatur, but not removing them, just cutting them off. Remove the remaining larger pieces and only then detach the remaining smaller pieces. This reduces the risk of damaging delicate elements.
 

0.08-0.2. In the event of changing the original height, the height of the supports should be changed.
 

PLA+HS, PLA+, PLA, PLA silk Recommended materials are listed in order from best to good.

 

 

Clean the plate thoroughly before printing.
Make sure the filament is dry and free from dirt. This can damage the print or weaken the supports