Magnetic Base Front Cover

I had a few of these magnetic bases and the faceplates were breaking after prolonged usage. So I designed a replacement since I couldn't find one. Very simple and quick print with no supports. If you're careful you and remove the on/off sticker on the face and reapply it to the newly printed plate. I printed it at a .2 setting and it looks great. I did Iron the upper most top surface to make it even smoother even though it will be inside of the mag-base and not seen. I also added a .1 under the precisions tab area to slightly enlarge the center hole to exactly 28.5mm but you may have your settings and calibrations dialed in and not need it.

Thanks for checking it out and I hope it can be of use to you as it was me.