Infiniti Strut Upper Seal/Gasket 55338-EG00A

This is a replacement Strut Mount Seal and was made to replace the OEM seal on a 2008 Infiniti G35x (part number 55338-EG00A), but may fit other Infiniti/Nissan models as well. It MUST be printed in a really tough material, like TPU for resistance to oil, grease and abrasion (https://en.wikipedia.org/wiki/Thermoplastic_polyurethane). Use at your own risk. This should cost you less than $0.15 per seal in material and about 30 minutes to print using TPU compared to the $60+ per seal for the OEM replacment. I used Priline TPU (Shore hardness 98A) which I've had really good results using (https://amzn.to/2HqkFK0). The OEM seal is 0.4mm thick, this version is 0.6mm thick so when printing at 0.2mm layers you'll get 3 layers. Scale up on the Z axis if you prefer a thicker seal, but make sure to have enough bottom/top layers to create a solid print. Note that pictured seal (test fit version) is slightly different from finalized .STL